D-Link DWL-G730AP Windows 8 Drivers Download (2019)


Download Now
D-Link DWL-G730AP Driver

Client Mode Step 1 Type IP address of the DWL-GAP in the address bar of web browser (default is ). Press Enter. Step 2 The default username. While not a necessity, the DWL-GAP is a highly convenient, inexpensive tool for frequent travellers. The wifi login username password for Dlink DWL-GAP.


D-Link DWL-G730AP Download Drivers

Type: Driver
Rating:
4.55
240 (4.55)
Downloads: 926
File Size: 13.94Mb
Supported systems: Windows 10, Windows 8.1, Windows 7
Price: Free* [*Free Registration Required]

Download Now
D-Link DWL-G730AP Driver

D-Link DWL-G730AP can easily fit into a pocket, but this won't be necessary since the device comes packed in a handy faux leather travel case. This eliminates the need to carry around the power adapter, but at the same time will cause your notebook's D-Link DWL-G730AP to run down a tiny bit faster.

D-Link DWL-G730AP Driver Windows 7

Towards the back of the device lies one LAN port that doubles as a WAN port when in router mode more on this latera power plug and a reset switch. D-Link DWL-G730AP As hinted above, the router can operate in three main modes -- D-Link DWL-G730AP point AP mode, client mode and router mode. Router mode is similar to AP mode, except here the device can also be used to share a single broadband Internet connection between multiple clients.

D link dwl gap in Client mode - Wireless Networking

Client mode enables you to connect to an existing wireless network, which is handy if your PC doesn't offer an integrated wireless chip. The default username is admin all lower case and the default D-Link DWL-G730AP is blank nothing.

Click on the Home tab and then click Wireless to the left. Step 4 On D-Link DWL-G730AP Wireless page you can configure the following settings: The SSID is a unique D-Link DWL-G730AP that identifies a network. All devices on a network must share the same SSID in order to communicate on the network.

D-Link DWL-G730AP Vista

It is recommended to change your SSID to something other than default. Channel — Channel 6 is the default channel.

To change the channel, select a value using the drop-down list next to Channel. Channels 1, 6, and 11 are the only non-overlapping channels.

D-Link DWL-G730AP Drivers for Windows XP

I appreciate any help, thanks in advance! I am having fits trying to get my link dwl to work in Client mode. I'm D-Link DWL-G730AP the same problem - did you happen to find a solution?

D-Link DWL-G730AP let you know if I do. I'm not sure I was doing anything wrong, but I do understand how it works now and will describe it here.

D-Link Technical Support

First of all, as in the documentation, the default address of the device to manage it is I was able to manage it on this address after performing a reset by powering down while holding down the reset button. I expect there is a slightly different method to just do a D-Link DWL-G730AP, as when I first hit the management page after that, it was in simple mode, asking for a firmware update file. I D-Link DWL-G730AP it again, and it had obtained factory defaults when I hit D-Link DWL-G730AP management page.

I went to the wireless section and put in my wireless network's ssid and WEP key.

Related Drivers